Heavy Load Caster Swivel Screw-in Type (Part Numbers)

Economy series Heavy Load Casters, Screw Type
Casters Material: Urethane (Brownish Red)
MISUMI economy series heavy load Casters, a cost-effective choice!

Part Number		Casters Material	Allowable Load (daN)
Type of Casters	D
E-CPSN	100	U (Urethane)	280

For more information on product of Casters specifications and dimensional drawings, please refer to the product catalog on the website.

■MISUMI’s heavy load fixed type Casters with excellent cost performance!! Save cost when used in large quantities.
■Body material is Q235, and surface treatment is zinc plating. Bearings are provided at the turning part and wheel part of the caster.
■ Advantages of MISUMI economy series Casters.
·MISUMI economy series casters are strictly tested in accordance with ANSI ICWM-2018 standard, and the loads are clearly indicated for more assured use.

■Test results of Casters under the same allowable load

■Precautions for Casters Use

【Precautions 1】
Do not exceed the allowable load when using it.
The allowable load in the product of Casters catalog is the load speed when manual transportation is carried on a flat ground.

【Precautions 2】Operating Speed
Use intermittently at a speed below the walking speed on a flat road. Please do not use it continuously through power traction or in a hot state

Casters diameter	Operating Speed
75mm or less	2km/h or less
100mm or less	4km/h or less

【Precautions 3】Stopper
Wear and damage caused by long-term use may unconsciously reduce the function of the Casters, so please pay attention.
Generally speaking, braking force varies with caster material.
Considering the safety of products, please take other measures (Casters, braking part) when especially necessary.

【Precautions 4】Operating Environment
Casters are usually used in the room temperature range.
Do not use in special environment affected by high temperature, low temperature, humidity, acid, alkali, salt, solvent, oil, sea water, medicine, etc.

【Precautions 5】Installation Method
① Please keep the mounting surface as balanced as possible.
② When mounting rotary (universal) Casters, the rotary axis should be in a vertical position.
③ When mounting fixed casters, keep the Casters parallel to each other.
④ Please confirm the mounting hole and mount it reliably with appropriate bolts and nuts to avoid looseness.
⑤ When mounting screw-in Casters, please tighten the hexagonal part of threads with proper torque. If the tightening torque is too large, it will lead to stress concentration in the shaft and cause fracture.
(Refer to the appropriate tightening torque of 20 to 50N・m with a thread diameter of 12mm)

Part Number		Wheel Material	Allowable Load (daN)
Type	D
E-CPSN	100	U (Urethane)	280

For more information on product specifications and dimensional drawings, please refer to the product catalog on the website.