PTFE Compensating Cable for K-Thermocouple (C-KAFF-100M-0.12MM)

Temperature Sensors, Thermocouple’s temperature measurement wire

Model: Temperature measurement range: -200 to 260°C (PTFE material) -200 to 500°C (glass fiber material)

Core diameter: 2*Φ0.127mm 2*0.214MM 2*0.511MM

1. It can be widely used in a temperature measurement environment with high accuracy requirements, such as recorders.
2. In addition, the temperature measurement wire solder joint processing service is provided.
3. It can be used with the K -type standard plug or high-temperature plug.

For more information on product dimensional drawings, please refer to the Temperature Sensors product catalog.

* Generic Temperature Sensors products in the market are similar products randomly purchased by our company from online or offline markets.
* The test data are obtained through testing by our company, which are for reference only

■ Temperature Sensors Features
· It is used when the temperature measurement point is exposed, so it responds faster than the sheath type.
· Temperature measurement can be performed at the point on the measured object.

Temperature Sensors Couples should not be installed too close to the door and heating place, and the insertion depth should be at least 8 to 10 times the diameter of the protection tube; the interval between the thermocouple protection bushing and the wall is not filled with insulation material, resulting in furnace heat overflow or cold air intrusion. Therefore, the interval between the thermocouple protection bushing and the furnace wall hole should be blocked with refractory mud or asbestos cord or other insulation materials so that the accuracy of temperature measurement will not be affected by hot and cold air convection; The cold end of the thermocouple is too close to the furnace, causing the temperature to rise above 100℃; thermocouples should be as far away as possible from strong magnetic and electric fields, so the thermocouples and power cable should not be installed in the same conduit to avoid deviation caused by interference; thermocouples can not be installed in the area where the measured medium rarely flow. Thermocouples must be installed against the direction of the flow and in full contact with the gas when the tube gas temperature is measured by thermocouples.